ATrack + FleetERP
AK, AL and AX series over the ATrack ASCII and binary protocols.
How it works
ATrack hardware is common in cold chain and container movement. FleetERP supports both the ASCII and binary variants and maps the device's serial-port sensor inputs into our reefer and load monitoring modules.
Direct TCP/UDP protocol listener on FleetERP's ingest gateway — point the device to our endpoint.
FleetERP has no commercial relationship with hardware vendors and earns nothing on devices. If you later switch away from ATrack, your history, reports and workflows stay exactly where they are.
What flows across
What ATrack data lights up in FleetERP
Integration data is not stored in a separate silo — it feeds directly into the operational modules that use it.
ATrack integration FAQ
Do we need to replace our ATrack setup to use FleetERP?
No. FleetERP is device-agnostic and does not sell hardware. Your existing ATrack deployment stays exactly as it is — direct TCP/UDP protocol listener on FleetERP's ingest gateway — point the device to our endpoint.
What data does FleetERP receive from ATrack?
GPS position, speed, heading and altitude; Ignition, digital inputs and outputs; Analogue sensor channels including fuel level; Device health, GSM signal and battery voltage; Driver ID from iButton or RFID reader.
How long does the ATrack integration take to set up?
Standard integrations are connected during week three of a normal 30-day rollout, alongside device onboarding. Most take a few hours of configuration rather than a project.
GPS & telematics devices
We do not manufacture hardware. We speak the protocol of the devices already fitted to your fleet.
Already running ATrack? You're most of the way there.
Book a demo and we will show you your own device data flowing into the platform during the call.
No per-user pricing · No hardware to buy · Deploy on your VPS or ours
Prefer to write? sales@fleeterp.in